From the loading ramp to intralogistics
The challenge and solution
Our customer approached us even before the construction phase of the new production hall, which enabled efficient project planning and smooth execution of the pits, etc. A lifting device was required for the outside area of the loading ramp and a solution for the inside area that would connect the two production levels. A throughput of 6 pallets with a total of 6 tons of raw goods was to be ensured with one lifting operation. Pits are required for loading/unloading at ground level, which were planned and perfectly integrated before construction began, taking into account the platform dimensions. Outside, a flexible loading lift table was to be used for loading/unloading sprinters and light trucks with and without tail lifts.
Customer sketch
Loading lift table
The loading lift table for outdoor use is hot-dip galvanized and equipped with an internal hydraulic unit
- Load capacity: 3,000 kg
- Platform dimensions: 2,500 x 2060 mm
- Lifting height: 1,600 mm
- Overall height: 345 mm
In addition, overloading flaps, plug-in railings, safety chain curtains and a safety portal are installed.
Further information in the following video and on the product page!
Single scissor lift table
The scissor lift table for indoor use is painted in RAL 7012 and equipped with an internal hydraulic unit
- Load capacity: 6,000 kg
- Platform dimensions: 3,000 x 2500 mm
- Lifting height: 1,600 mm
- Overall height: 460 mm
In addition, anti-tippers, safety chain curtain, pilot valve on the hydraulic cylinder, railings with doors and a safety portal are installed.
Further information in the following video and on the product page!